to support the discussion in 9448.dat
https://library.ldraw.org/parts/27031
i made some pics of my parts:
from top to bottom:
-long cylinder (7.5mm), long magnet (D10mmxL7mm), overall cylinder length 8mm
-short cylinder (6.5mm), long magnet (D10mmxL7mm), overall cylinder length 8mm
-short cylinder (6.5mm), short magnet (D10mmxL6mm), overall cylinder length 7mm (these are too short to connect)
-"modern" magnet (2959c01.dat) with the holder (2607.dat) (magnet size D10mmxL7mm)
Also, the rear connector is always the same (could be subfiled)
I have more train magnets but have to dig them out...
i tested them, but i guess due to the age the older ones are weaker.
https://library.ldraw.org/parts/27031
i made some pics of my parts:
from top to bottom:
-long cylinder (7.5mm), long magnet (D10mmxL7mm), overall cylinder length 8mm
-short cylinder (6.5mm), long magnet (D10mmxL7mm), overall cylinder length 8mm
-short cylinder (6.5mm), short magnet (D10mmxL6mm), overall cylinder length 7mm (these are too short to connect)
-"modern" magnet (2959c01.dat) with the holder (2607.dat) (magnet size D10mmxL7mm)
Also, the rear connector is always the same (could be subfiled)
I have more train magnets but have to dig them out...
i tested them, but i guess due to the age the older ones are weaker.