Complete rework of parts and further questions


RE: Complete rework of parts and further questions
#21
(2024-10-30, 19:52)Manfred Schaefer Wrote: How many decimal places are useful for a flat pattern?
In one part on the Parts Tracker, two was mentioned as a comment. Which I would also consider sufficient. Is two a rule, or just a recommendation, or should the value be greater?

There's no hard rule. Typically 2 or 3 depending on size of pattern and how it looks. Anything more than 3 you should probably justify with a comment. 

Personally, I'd just go with 3.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: Complete rework of parts and further questions - by Orion Pobursky - 2024-10-30, 20:28

Forum Jump:


Users browsing this thread: 1 Guest(s)