I want to restructure the cannon with rounded bottom.
I think we now have a good structure on the flat version.
But:
I can do all the steps described above.
When would it be ok to make these changes? Before or after Gerald is done with the geometry correction?
I think we now have a good structure on the flat version.
But:
- 57029 and 57759 should use Bottom not Base.
- I want to remove with Trigger from the assemblies.
- And the paranthesis (with/without an Arrow). Wouldn't "Unloaded" / "Loaded" be enough?
- I want to renumber 76100c01 to 76100c02. That would make it similar to 57796c02
- Then I want to renumber 76100-f1 to 76100c01.
- 32074c01 need to be a ~Move to 76100c01
- This would make 76100-f2 unnecessary.
- What name should we use on the parts? Body/Lid ? Barrel/Front Cover?
- 32074c02 should be used in the 76100 assemblies.
- The spring should be added in the 76100 assemblies
- What number should be used on the assy of 57796 with Long/Short trigger? a/b-version or continue to c03/c04?
- But it might be necessary to use Short/Long Trigger in the descriptions?
- Should Competition stay in the description?
I can do all the steps described above.
When would it be ok to make these changes? Before or after Gerald is done with the geometry correction?