Hello,
I wanted to do the patterned versions of the old minifig baseball cap (part 4485), so I looked into the official file to see how it could be sub-filed.
While doing this, I discovered a slight difference to the real part regarding the angle of the bill and a few proportion issues. The LDD version seems to be somewhat closer to the real part:
Do you think this part should be entirely reworked or should I just try to sub-file the old version for the patterns?
I already did a simple clean-up of the LDD part, however there are still a few issues with the stud connector and the question if the top part can or should be replaced with a sphere primitive (it connects to a lot of non-primitive areas so it will probably look odd in some resolutions).
I wanted to do the patterned versions of the old minifig baseball cap (part 4485), so I looked into the official file to see how it could be sub-filed.
While doing this, I discovered a slight difference to the real part regarding the angle of the bill and a few proportion issues. The LDD version seems to be somewhat closer to the real part:
Do you think this part should be entirely reworked or should I just try to sub-file the old version for the patterns?
I already did a simple clean-up of the LDD part, however there are still a few issues with the stud connector and the question if the top part can or should be replaced with a sphere primitive (it connects to a lot of non-primitive areas so it will probably look odd in some resolutions).