LDCad 1.7 Beta 1 (win+linux)

[Sam Potter]

Yes, by editing or adding the grid configuration. 'Mesh with spanner' icon in toolbar just before the two hart ones.

thanks 

searching the forum i found this
"Philippe Hurbain Wrote:
What is the Freq parameter in grid stepping configuration?
It's used for the rendering of the grid lines / rotation disc segments. With move it governs the frequency of the the white lines vs the grey ones, with rotation it controls how many steps a segment on the disc represents."

i'm not sure i get it,  also what is "slide"?
can you please elaborate