I'm in the process of correcting these parts now.
This makes it necessary to obsolete a bunch of parts due to bad geometry. But how do I pick a new number for the reworked parts?
I think the practice here is to make a b-version. 2447 will become 2447b.
The base part is helmet 2446. There are three prints made and a couple of suggested assemblies.
2446 is an old number that went out of production 2002. It has been replaced by 30124. We have 30124 as an alias of 2446.
The helmet is known at Bricklink as 2446, but is only known as 30124 at Brickset.
Would it be possible to just obsolete 2446, and then reuse 30124 as the recreated version, or do I need to obsolete it too, and make 30124b?
Many of the different visors might be possible to use as is on the new helmet. Only minor adjustments are needed and they have a good origin.
My plan is to make a b-version of all visors that have a bad origin, not in the centre of the rotation point.
This makes it necessary to obsolete a bunch of parts due to bad geometry. But how do I pick a new number for the reworked parts?
I think the practice here is to make a b-version. 2447 will become 2447b.
The base part is helmet 2446. There are three prints made and a couple of suggested assemblies.
2446 is an old number that went out of production 2002. It has been replaced by 30124. We have 30124 as an alias of 2446.
The helmet is known at Bricklink as 2446, but is only known as 30124 at Brickset.
Would it be possible to just obsolete 2446, and then reuse 30124 as the recreated version, or do I need to obsolete it too, and make 30124b?
Many of the different visors might be possible to use as is on the new helmet. Only minor adjustments are needed and they have a good origin.
My plan is to make a b-version of all visors that have a bad origin, not in the centre of the rotation point.