Mirroring 42938


Mirroring 42938
#1
I've been trying to figure out the LDCad mirror meta parameters needed for "Car Track 16 x  8 x  2 Curve".

Normally you set a rotation point and rotate the part into its own counter part.

But I'm having problems determining that point as the part seems to be slightly off.

I think it should be half x of the highest point at the arc between the 2 red bricks.

But the two red bricks use different x values (non symmetrical?).

It should probably be close to 172 0 0, but this puts it on 320.956369 0 86 instead of 320 0 086

   

Is this part just not suitable for mirroring or I'm a missing something, thoughts?

current shadow:
Code:
0 LDCad shadow info for "Car Track 16 x  8 x  2 Curve"

0 Author: LDCad Shadow Library
0 !LICENSE CC BY-SA 4.0, see LICENSE.md

0 !HISTORY 2024-06-07 {Roland Melkert} Initial info for 42938.dat

0 !LDCAD SNAP_CLEAR [ID=stud3]
0 !LDCAD SNAP_CYL [gender=F] [caps=one] [secs=S 6 20] [pos=165.644 24 -21.807] [ori=0.96592587 0 0.25881889 0 1 0 -0.25881889 0 0.96592587] [grid=C 2 C 2 20 140]

0 //TODO: posCor needs better value.
0 !LDCAD MIRROR_INFO [baseFlip=Z] [counterPart=self] [posCor=172 0 0] [oriCor=-0.866025 0 0.5 0 1 0 -0.5 0 -0.866025]
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Mirroring 42938 - by Roland Melkert - 2024-06-07, 1:00
RE: Mirroring 42938 - by Roland Melkert - 2024-06-07, 6:22

Forum Jump:


Users browsing this thread: 1 Guest(s)