(2024-05-19, 22:48)N. W. Perry Wrote: Right, and in particular from the STEP command being optional(?) for the last step. I think the LPub behavior is what I'd really like—ignore the final step unless it contains non-whitespace lines. (I would say unless it contains parts, but there are cases where official instructions have steps where no parts are added, such as connecting two assemblies, or swinging a hinge into place, etc. So you might use a comment line to make such a step appear.)With LDCad being an editor, I don't think it should hide empty steps. But I have been thinking about a instruction/booklet mode for the 2.0 version.
As for the rotation step stuff, currently I'm leaning towards adding a 'favourites' for step configurations. And one of those can be set as a default.