Updating the Prim Ref page


RE: Updating the Prim Ref page
#82
(2024-01-25, 8:28)Travis Cobbs Wrote: Since I never got a satisfactory answer regarding what to do past one quarter circle for helical primitives, I will only be supporting up to one quarter circle. If higher fractions are created in the future, I may revisit and support them, but the initial support in the next LDView release will not substitute them at all past one quarter circle.
For the helical cylis it doesn't make much sense above 1/4 because it becomes too wide. So limiting to 1-4 is fine!
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: Updating the Prim Ref page - by Philippe Hurbain - 2024-01-25, 9:43

Forum Jump:


Users browsing this thread: 14 Guest(s)