[Solved] Making stickers from scratch

[Rene Rechthaler]

It works! As flat sticker, not a printed tile. Now removing dotted area makes sense




I tried it in Ldcad and it works too, but there are problems that are not in other stickers:

It does not "snap" to the plate. The Y position of sticker is -1 and 0 for tile. If the sticker position is on 0 then it is inside the tile and not clearly visible. Other stickers snap perfectly


The pattern is visible on the oppoiste side too, but mirrored. Not on other stickers


Please note that all 3 parts are on Y=0 position

Do you have a "sticker body"? Normally all stickers are 0,25 LDU thick (the print is at -0,25).

That means you need a base (at Y=0) and sides to get a solid body (everything except the printed side has color 16).

Watch out for BFC and use prims (1-4 cyli and 1-4chrd to get the rounded edges).