(2022-12-04, 3:27)N. W. Perry Wrote: Oh, I'm going to build it anyway. :-)
Yes you must do it. 2 weeks of work. If you use LDCAd, set the round parameter to 4 minimum (I used 5). ModelFileDecCnt=3 to 4 or 5
Each floor have 2 rotation angle on 26047.dat, 1 on the stud (1st), 1 on the clip (2nd).
1 - Stud 27.7437, clip 29.2067
2 - Stud 12.8396, clip 12.2295
3int - Stud 4.096, clip 3.7481
3ext - Stud 7.3871, clip 7.0413
Flag : 45
