RE: Sail 9 x 11 with 3 Holes (Pirates)
2022-09-19, 7:35 (This post was last modified: 2022-09-19, 7:36 by Philippe Hurbain.)
2022-09-19, 7:35 (This post was last modified: 2022-09-19, 7:36 by Philippe Hurbain.)
(2022-09-18, 19:39)N. W. Perry Wrote: While we're on the subject, what's the typical process for creating formed versions of a part like this?
It's a very manual process. I create the flat sail surface, then slice it and bend each section till the attachment holes fit correctly the masts... I then either duplicate/translate the surface and create the edge (if curvature is low enough) or make an extrusion (with Meshmixer) if curvature is too high.