I'm now creating this one in set 6551 and 6648:
https://www.bricklink.com/v2/catalog/cat...=5#T=C&C=5
It is not a STAMP shortcut, but it will apparently violate this regulation in
https://www.ldraw.org/article/512.html#s..._shortcuts
"The sticker(s) must entirely fit on the part, with no portions of the sticker(s) extending beyond the boundaries of the part."
The topology itself is the same as the funnel sticker.
Should I make a formed sticker like 168365fc01 only,
https://www.ldraw.org/cgi-bin/ptdetail.c...65fc01.dat
and not a sticker shortcut 2569d01?
https://www.bricklink.com/v2/catalog/cat...=5#T=C&C=5
It is not a STAMP shortcut, but it will apparently violate this regulation in
https://www.ldraw.org/article/512.html#s..._shortcuts
"The sticker(s) must entirely fit on the part, with no portions of the sticker(s) extending beyond the boundaries of the part."
The topology itself is the same as the funnel sticker.
Should I make a formed sticker like 168365fc01 only,
https://www.ldraw.org/cgi-bin/ptdetail.c...65fc01.dat
and not a sticker shortcut 2569d01?