As there are some chrd and ering prims in the next batch of axleholes, I raised a question there on how to properly fit axleholes.
https://forums.ldraw.org/thread-23835-po...l#pid45678
so far Philo has replied, but I think it is something we should consider:
a) Not using chrd and ering in the axle prims
Let the user of the axlehole decide how to embed it, so the user can choose if it will be embedded in a ndis/ring and add the necessary 4-4ering themselves, or use triangles/quads
b) using chrd/ering in the axlehole prims
This would imply that an Axlehole is always embedded in a ndis/ring
Embedding it in surfaces would lead to overlapping surfaces
https://forums.ldraw.org/thread-23835-po...l#pid45678
so far Philo has replied, but I think it is something we should consider:
a) Not using chrd and ering in the axle prims
Let the user of the axlehole decide how to embed it, so the user can choose if it will be embedded in a ndis/ring and add the necessary 4-4ering themselves, or use triangles/quads
b) using chrd/ering in the axlehole prims
This would imply that an Axlehole is always embedded in a ndis/ring
Embedding it in surfaces would lead to overlapping surfaces