(2022-04-01, 19:37)Violet Barrett Wrote: The issue is the fact that a lot of high quality parts exist already, but having been traditionally 3d modeled, are not up to spec with LDraw. Is there a way to take these models and introduce primitives where connection points exist without remodeling the whole thing?
Also, I'll definitely want to raise a few questions regarding the next spec revision. Apologies if this is a stupid question, but where can I go to propose additions to the standard? I'm new to this forum, and having a bit of a tricky time navigating it!
1. Basically, you remove geometry of the connectivity points, and add primitives in place of them, it isn't too hard to do with good model on hands
2. Official File Specifications/Standards forum, can be found here: https://forums.ldraw.org/forum-32.html