Please help: I'm new to this and can't find the parts...
2012-04-22, 10:02 (This post was last modified: 2012-04-23, 2:58 by Jon H.)
2012-04-22, 10:02 (This post was last modified: 2012-04-23, 2:58 by Jon H.)
Hi,
I just downloaded LDRAW and MLCAD today to try it out.
A couple of questions:
1.
I can't find this part when using MLCAD;
http://www.bricklink.com/catalogItemIn.asp?P=88930&in=S
Slope, Curved 2 x 4 x 2/3 No Studs with Bottom Tubes
2.
I'm not sure if I have the latest and full parts available...
Here is what I think I did:
The first parts list I downloaded "complete.exe" was approx 5mb (I think) and it seemed really basic.
i followed the instructions and used the command prompt etc.
then I downloaded another one, "complete.zip" and it was 17.1 mb approx... I think I installed it, i extracted it into the ldraw folder... it asked if I wanted to replace some files... i said yes.
But the parts seem the same on MLCAD... is there another step i've missed?
Any suggestions would be appreciated.
Jon
I just downloaded LDRAW and MLCAD today to try it out.
A couple of questions:
1.
I can't find this part when using MLCAD;
http://www.bricklink.com/catalogItemIn.asp?P=88930&in=S
Slope, Curved 2 x 4 x 2/3 No Studs with Bottom Tubes
2.
I'm not sure if I have the latest and full parts available...
Here is what I think I did:
The first parts list I downloaded "complete.exe" was approx 5mb (I think) and it seemed really basic.
i followed the instructions and used the command prompt etc.
then I downloaded another one, "complete.zip" and it was 17.1 mb approx... I think I installed it, i extracted it into the ldraw folder... it asked if I wanted to replace some files... i said yes.
But the parts seem the same on MLCAD... is there another step i've missed?
Any suggestions would be appreciated.
Jon