RE: part request: 77765
2021-09-16, 21:19 (This post was last modified: 2021-09-16, 21:28 by SNIPE.)
2021-09-16, 21:19 (This post was last modified: 2021-09-16, 21:28 by SNIPE.)
Hi,
It does indeed accept a light saber hilt and 1L either side of it with friction:
https://ibb.co/0ZMWb4y
https://ibb.co/vsn4BVY
https://ibb.co/XbWzd8Q
https://ibb.co/XknfPz9
However shorter bars such as barraki eyes do not have any friction and they fall out but this shouldn't matter for ldraw.
One caveat is that the barraki eyes fit in the opening end but the mould lines fit between the notches on the end of the pin, then it has friction.
Here it is with the mould lines inside of the slots:
https://ibb.co/S5DTQFg
And this is far in as it goes when the mould lines are not aligned with the slots:
https://ibb.co/1vpfNGT
It does indeed accept a light saber hilt and 1L either side of it with friction:
https://ibb.co/0ZMWb4y
https://ibb.co/vsn4BVY
https://ibb.co/XbWzd8Q
https://ibb.co/XknfPz9
However shorter bars such as barraki eyes do not have any friction and they fall out but this shouldn't matter for ldraw.
One caveat is that the barraki eyes fit in the opening end but the mould lines fit between the notches on the end of the pin, then it has friction.
Here it is with the mould lines inside of the slots:
https://ibb.co/S5DTQFg
And this is far in as it goes when the mould lines are not aligned with the slots:
https://ibb.co/1vpfNGT