(2021-06-01, 21:44)Jeremie Guillaume Wrote: It's a nice surprise. And stickers already exist !! (on my side I began making this one only very recently, so I hadn't checked yet for their existence in the library).
I think you should OMRize it for inclusion in the OMR
One possible enhancement would be to make separate LDR's for the four corner baseplates, which are intended to rotate and allow opening one entire side or the other of the castle. That would make using that feature of the original model easier IMO.
To be honest I'd just assumed the castle was already in the OMR! But at some point I might get around to OMRizing it; at that point, I would typically put the rotating sections into LDCad groups rather than submodels (since I use submodels to reflect the build process and match the instructions).