The unmatched edges around my part, should I add edgelines there? And if so, how do I do that? Edger2 seems only be able to create umatched edges in red...
Wow, and then I used Edger2 to create conditional lines. It did that. About 150. And I only need about 20. How do I find out which condlines are needed and which not, without going through every line of code? Because, I think, when you advanced authors look at the code you can see lines, triangles, etc, I only see a bunch of numbers and have to put a 0 in front of every line to see, which line disappears. Really, condlines are starting to p*** me off.
Wow, and then I used Edger2 to create conditional lines. It did that. About 150. And I only need about 20. How do I find out which condlines are needed and which not, without going through every line of code? Because, I think, when you advanced authors look at the code you can see lines, triangles, etc, I only see a bunch of numbers and have to put a 0 in front of every line to see, which line disappears. Really, condlines are starting to p*** me off.