Hi guys
I was asked a question that I couldn't answer 100 percent. As far as I know, it doesn't work.
Here's the question:
Hi Johann. Is there a possibility to move the kinematics in the LDcad? Example: I have a rectangle built from individual parts and want to move it to a parallelogram by twisting an arm around its pin at one of the joints. In the LDD, if you built the joints according to a certain scheme, then the movement of the remaining parts ran smoothly.
Johann
I was asked a question that I couldn't answer 100 percent. As far as I know, it doesn't work.
Here's the question:
Hi Johann. Is there a possibility to move the kinematics in the LDcad? Example: I have a rectangle built from individual parts and want to move it to a parallelogram by twisting an arm around its pin at one of the joints. In the LDD, if you built the joints according to a certain scheme, then the movement of the remaining parts ran smoothly.
Johann
If nothing goes right, go left.