RE: Detail View
2020-11-15, 19:40 (This post was last modified: 2020-11-15, 20:37 by David Lang.)
2020-11-15, 19:40 (This post was last modified: 2020-11-15, 20:37 by David Lang.)
Well, now I fiddled a lot to get some good results, but I have not found a solution to show only a specific area of the 1m tall tower of my crane...
Usage of submodels is unfortunatelly hardly possible for the crane structure.
And the second suggestion (useage of pictures) is possible, but very time consuming and the result didn´t look anyhow handsome...
When I set the scale factor to high values, the parts are clearly visible, but unfortunatelly LPub3D centers the rendering to the middle of the structure and crops the borders at the edges of the page.
Is there somehow a possibility, to define which part of the assembly should be focused and centered on when rendering too big scales? So that the rendering will show the top of the tower and not the middle of the tower? Somehow as shown in the second picture would be nice...
Really frustration, I thought this should be possible somehow in LPub3D...
Usage of submodels is unfortunatelly hardly possible for the crane structure.
And the second suggestion (useage of pictures) is possible, but very time consuming and the result didn´t look anyhow handsome...
When I set the scale factor to high values, the parts are clearly visible, but unfortunatelly LPub3D centers the rendering to the middle of the structure and crops the borders at the edges of the page.
Is there somehow a possibility, to define which part of the assembly should be focused and centered on when rendering too big scales? So that the rendering will show the top of the tower and not the middle of the tower? Somehow as shown in the second picture would be nice...
Really frustration, I thought this should be possible somehow in LPub3D...