(2020-10-08, 16:09)Gerald Lasser Wrote: I started authoring it already, I made them like this, which represents them very accurate
1 16 0 0 0 4 0 0 0 22.7 0 0 0 4 4-4cylc.dat
1 16 0 23.45 0 2 0 0 0 -.75 0 0 0 2 4-4con2.dat
1 16 0 23.45 0 6 0 0 0 2 0 0 0 6 4-4cylo.dat
1 16 0 25.45 0 2 0 0 0 .75 0 0 0 2 4-4con2.dat
1 16 0 26.2 0 4 0 0 0 1 0 0 0 4 4-4cylo.dat
1 16 0 27.95 0 2 0 0 0 -.75 0 0 0 2 4-4con2.dat
1 16 0 27.95 0 6 0 0 0 2 0 0 0 6 4-4cylo.dat
1 16 0 29.95 0 2 0 0 0 .75 0 0 0 2 4-4con2.dat
1 16 0 30.7 0 4 0 0 0 1 0 0 0 4 4-4cylo.dat
1 16 0 32.45 0 2 0 0 0 -.75 0 0 0 2 4-4con2.dat
1 16 0 32.45 0 6 0 0 0 2 0 0 0 6 4-4cylo.dat
1 16 0 34.45 0 2 0 0 0 .75 0 0 0 2 4-4con2.dat
Feel free to go ahead!
I was actually thinking of these:
Just inverted half-cylinders (with a spherical end), I think? Can't quite make it out from photos.
Also, is the top of the stud2 flush with the rim of the dish? Or is it actually recessed a bit, as in the LDD mesh?