[LPub] Change the view of a Callout

[Manfred Schaefer]

Hi Manfred

I have no idea why it doesn't work for you, but the following solution:
Replace the ROTSTEP command in the callout submodel (Marked red above)with "0 ROTSTEP 0 0 180 REL" then it should work for you too.

Regards Johann

Hello Johann,

Thank you for your prompt reply. With this change, it works.
You think the reason for this failure is my system?
I had tried it on another PC before and the result was the same.
The next days I will do a new installation of the LDRAW-suite.

Can you tell me how the ROTSTEP command or the transformation matrix affects the display of the CALLOUT.
I can't explain to me why the ROTSTEP command in the sub-model was the solution to my problem.

Thank you.

Regards

Manfred