[LPub] Change the view of a Callout

[Johann Eisner]

Thanks Johann.
First I used the matrix to rotate the sub part, but the parts in the callout was also rotated. I can not make any changes in the sub part as this will affect the first time the sub part is used.

Regards

Manfred

Hi Manfred

I can't understand you.
You have only to change the last "1" in the callout line to a "-1" and he callout should be shown correct.

  PIC-3.PNG (Size: 15.21 KB / Downloads: 56)

I made a quick project, and it works fine.
   

Code is attached.