[LPub] Change the view of a Callout

[Manfred Schaefer]

Hello,

I use one sub-models twice, but the second time the sub-model was rotatet by 180°. In the following picture you can see the first use of the sub-model and the callout.


  PIC-1.PNG (Size: 17.56 KB / Downloads: 68)

In the following picture you can see the second use of the same sub-model and the callout.


  PIC-2.PNG (Size: 15.68 KB / Downloads: 70)

What do I have to do to make the second callout look the same as the first callout?
In the following picture you can see a part of the "code" for the instruction.


  PIC-3.PNG (Size: 13.38 KB / Downloads: 68)

Regards

Manfred