Part 4210 (hose reel)

[N. W. Perry]

I think I would make a 1/4 subfile with 11 teeth, or maybe better, a 1/8 with 5,5 teeth.

I'll do the 1/8th then, since it solves both problems (accurate number of teeth, and greater use of subfiles).

Attach the inner side to a 4-4ndis around the shaft, and hide the outside under the smaller cone.

So the ndis on the inside replaces the disc that's there now? And the cone just the way I have it now, hiding the outside of the subpart?

(By the way, my current version is based on 2585.dat as far as how the prims overlap the teeth subfile. But I can see how the ndisc is an improvement.)

btw.
dont use the stud3 primitive like that. I know it was used like that in the old file, but must be corrected now.

OK, I'll replace it. What should it be, a cylc?

And for the pinhole, I'm thinking a cyl, a cone and a cylj (subfiled of course)?