[LDCad] Problem exporting model to ldd

[Moe]

Many of the axle pins are rotated wrong, some pins are not inline with the beams they connected to. These kinds of parts will be dropped by LDD.

You should really use part snapping with these kinds of models. To do so change the red GS into a green PS inside the compass, or use shift+p while the mouse is inside the editing area.

To correct the model you would need to grab and realign (using snapping) each part one by one.

Luckily you have included building steps so you can realign things from the bottom up while hiding everything else.

I was reading about LPub3D to make instructions. Would that give me the same problem as LDD or should I just stick to LDD and and use the snapping tool to fix the issues you mentioned?