Thank you everyone.
I'll take it easy as the part connects others only on the bottom and is very rare.
The photo of the part with different pattern on here;
https://www.bricklink.com/v2/catalog/cat...5D#T=C&C=1
looks very helpful to build 3D model.
The pole is a little more than 8 studs (160 LDU) or 7 bricks (168 LDU) high, and the slant amount is almost exact to 1 stud (20 LDU), aligning the edges of sign board and base in line.
And it has third support beam near the lower corner on the board.
I'd like to try it!!
I'll take it easy as the part connects others only on the bottom and is very rare.
The photo of the part with different pattern on here;
https://www.bricklink.com/v2/catalog/cat...5D#T=C&C=1
looks very helpful to build 3D model.
The pole is a little more than 8 studs (160 LDU) or 7 bricks (168 LDU) high, and the slant amount is almost exact to 1 stud (20 LDU), aligning the edges of sign board and base in line.
And it has third support beam near the lower corner on the board.
I'd like to try it!!