(2019-12-01, 19:17)GeraldĀ Lasser Wrote: When reviewing 18909, I noticed that the 3D Viewer renders a stud logo for stud6, I think it should not.I just checked 18909 in dark blue from the Rexcelsior. The part has LEGO-logos in the bottom. However. The studs appear to be "stud2" rather than "stud6" as there are no flat section of the outer cylinder. Also. The studs should be oriented so the LEGO-logo has the bottom toward the flat cross section (where the other 18909 would be in a cone).
3D Viewer work
« Next Oldest | Next Newest »
Users browsing this thread: 35 Guest(s)