My First Part author 3039pb007 Slope Brick 45 2 x 2 with "3" Number Pattern

[Victor Di Rienzo]

The first file (the DAT file) is the way to go.  However: 

1) Please check with Chris Dee for a proper pattern number, for the filename.  

2) If there are any other slope bricks of this type with a printed "3", please consider putting the pattern code into a sub-file, so you can re-use the code for the other "3" patterns.  

3) A more proper Title would be: 


(The Title should mention what color the "3" is printed in.)  

Again, looks good!  Get these points taken care of, and you should be ready to upload your file to the Parts Tracker.  ;-)  

Franklin

i have made as you recommended.

1 made a new subfile with the pattern "3"
2 Generated the file loading the subfile.