Ldcad part alignment

[Victor Di Rienzo]

Seems that something with your snapping doesn't work correctly.
I tried this just now and finished with all axles aligned after a couple of minutes.

Maybe you should check the settings of your shadow library or your snapping setting in LDCad itself.





Max

i was able to remake the part, using relative grid and was much faster it took me a pair of minutes. but as you can notice, this brick has an angle of 157.5 degrees, the default grid cant make smalers steps that 1°

so we can only make an aproximation, by the moment if good for me

thank you very much.