LPub3D - Submodel not shown in main model

[Jaco van der Molen]

Ahhhh....
I understand now.
Thanks.

Good!
Just choose Convert to Callout when the submodels are encountered and then manually edit the metacommands.
LPub converts 2 or more of the same submodel right after each other to one callout with x times used indication.
The behavior is similar to where you would use the same submodel in later steps in the model.

The only thing that you cannot do is display the callout in different ways, i.e. with rotation steps.
Since you work in the same submodel of course.