One more question, for sure.
I've done a little research now.
So far, there are two parts that are printed and I suspect it will be even more.
Would it make sense to move the part 6239.dat (without side surfaces) into a subpart --> 6239s01.dat . (see Attachment)
That way we could make printed parts better in the future.
Regards Johann
I've done a little research now.
So far, there are two parts that are printed and I suspect it will be even more.
Would it make sense to move the part 6239.dat (without side surfaces) into a subpart --> 6239s01.dat . (see Attachment)
That way we could make printed parts better in the future.
Regards Johann
If nothing goes right, go left.