Studio 2.0 review

[Philippe Hurbain]

Those settings are so High, the model is noticeably off the ground!

As I told above, this is caused by the bounding box of tires, artificially lowering the ground level. I was too lazy to regenerate the very high quality...

How does it handle an import of LDraw file? i.e. how feasible is it to make the model in LDCad and then generate instructions/renders in Studio?

Mostly, very well. Actually, the full flow was

• create the model in Stud.io
  
• export it to LDraw
  
• Use LDCad to correct inaccuracies and generate the rubber band
  
• Reimport the result in Stud.io
  
• Generate renders and BIs
  

The import/export went on completely flawlessly. BUT (that's why I used "Mostly"), the latest parts added to Studio show incompatibilities when exported to LDraw. I reported the issue on BL forum, but no answer so far. See http://forum.bricklink.com/viewtopic.php...37efe1b3ee