Insert callout final step near PLI in the first step

[Simone]

Hello again Johann
i still use your wonderful trick to show at the first step the final model.
Now i would like to show two of them, one under the other.
In the first I would like to show the complete final global model while in the second I would like to show the complete model of the submodel I am going to build. As in this example.



I tried to copy / paste your code 2 times and to move them manually using CALLOUT PLACEMENT values so as not to make them appear on top of each other but it creates confusion with the first real construction step then.
In your opinion there is a way to show 2 CALLOUT ASSEMBLED one under the other without making them interfere with each other and with the steps?
I also tried to use STEP command but obviously it place the number 1 on the second callout, and the first building step will be 2 and so on. And that is not correct.

Thanks
regards