Hi Roland.
I was surprised why so many same parts are shown in the part bin - and then I found this is a rendering bug, visible not only in the part bin but in the model as well: Trans Clear parts with print on them are shown as not having any pattern when viewed from the back side. So, for example, all panels look same on the attached part bin screenshot.
If it is not a worth to fix this in 1.6b, can you fix it in 2.0?
I was surprised why so many same parts are shown in the part bin - and then I found this is a rendering bug, visible not only in the part bin but in the model as well: Trans Clear parts with print on them are shown as not having any pattern when viewed from the back side. So, for example, all panels look same on the attached part bin screenshot.
If it is not a worth to fix this in 1.6b, can you fix it in 2.0?