good news! here's some feedback:
good:
(1)
the permanent insertion of 0 BFC CERTIFY INVERTNEXT is finally gone, hurray :-)))
(2)
uses ldconfig.ldr now, hurray
bad:
(1)
the tool still inserts stray empty lines
0
at each file's end upon saving
(2)
the tool still inserts
0 ROTATION CENTER ...
0 ROTATION CONFIG ...
lines at the file beginning.
I suggest that there should be an option which allows the user to turn on and off this saving.
EDIT:
(3)
The background color setting is not saved reliably.
When I set it to color code 68 ("very light orange") and close and restart MLCad,
it comes up with an all-white background instead of 68.
The same goes when choosing a custom color and e.g. configuring it to 0x04333FEB.
It comes up with white background on restart.
good:
(1)
the permanent insertion of 0 BFC CERTIFY INVERTNEXT is finally gone, hurray :-)))
(2)
uses ldconfig.ldr now, hurray
bad:
(1)
the tool still inserts stray empty lines
0
at each file's end upon saving
(2)
the tool still inserts
0 ROTATION CENTER ...
0 ROTATION CONFIG ...
lines at the file beginning.
I suggest that there should be an option which allows the user to turn on and off this saving.
EDIT:
(3)
The background color setting is not saved reliably.
When I set it to color code 68 ("very light orange") and close and restart MLCad,
it comes up with an all-white background instead of 68.
The same goes when choosing a custom color and e.g. configuring it to 0x04333FEB.
It comes up with white background on restart.