If there is a slight vertex mismatch in the mesh, LDPE Edger2 creates (utterly) wrong condlines.
See attached example
- 3626bsurface.dat is a minifig face, obtained by inlining of cylinder and tori, and removing all existing condlines. It does contain slight mismatches (d=0.0004).
- 3626bsurface-cl.dat is the buggy result of Edger2 on that mesh.
- 3626bsurface-cl-u.dat is the correct result, obtained by first unifying mesh, then running Edger2
See attached example
- 3626bsurface.dat is a minifig face, obtained by inlining of cylinder and tori, and removing all existing condlines. It does contain slight mismatches (d=0.0004).
- 3626bsurface-cl.dat is the buggy result of Edger2 on that mesh.
- 3626bsurface-cl-u.dat is the correct result, obtained by first unifying mesh, then running Edger2