RE: [LDPartEditor] LDPE Edger2 bug?
2017-05-23, 11:54 (This post was last modified: 2017-05-23, 12:18 by Philippe Hurbain.)
2017-05-23, 11:54 (This post was last modified: 2017-05-23, 12:18 by Philippe Hurbain.)
Looks like LDPE embedded Edger2 sometimes creates erroneous edge lines in flat areas... Attached the original file, result with command line Edger2, result with LDPE Edger2. Problem occurs near the tread rounded tips of tread. Default parameters, no generation of unmatched lines.
Found the culprit: overlapping surfaces. I was fooled because minute rounding errors made these overlaps unnoticed by LDPE duplicate detection engine.
Found the culprit: overlapping surfaces. I was fooled because minute rounding errors made these overlaps unnoticed by LDPE duplicate detection engine.