Philippe Hurbain
For simple tasks like this MLCad can do the trick (but it doesn't allow to cut and paste between two different files so you will probably need a text editor too in the process...
Thanks Philippe - I used LDPartEditor to extract the logo part and created a new file called "batman_logo_small.dat". I then added this to the part 47753.dat in an attempt to create this part:
http://www.bricklink.com/v2/catalog/cata...5#T=C&C=11
This brick+sticker is featured in this set:
http://brickset.com/sets/7780-1/The-Batb...iller-Croc
I guess the sticker part could be "embedded" into the 47753 part to make a new part? Would this then be a new "official" LDraw part?
Could you take a look at the sticker alignment on the wedge brick? How close should this be to the surface of the brick? The relevant files are attached
(2017-01-04, 7:53)Reuben Pearse Wrote: What's the best tool for selecting/extracting certain parts of an existing part file? (other than Notepad++)The best tool nowadays is LDPartEditor (http://nilsschmidt1337.github.io/ldparteditor/).
For simple tasks like this MLCad can do the trick (but it doesn't allow to cut and paste between two different files so you will probably need a text editor too in the process...
Thanks Philippe - I used LDPartEditor to extract the logo part and created a new file called "batman_logo_small.dat". I then added this to the part 47753.dat in an attempt to create this part:
http://www.bricklink.com/v2/catalog/cata...5#T=C&C=11
This brick+sticker is featured in this set:
http://brickset.com/sets/7780-1/The-Batb...iller-Croc
I guess the sticker part could be "embedded" into the 47753 part to make a new part? Would this then be a new "official" LDraw part?
Could you take a look at the sticker alignment on the wedge brick? How close should this be to the surface of the brick? The relevant files are attached