[LDPartEditor] 0.8.25 Beta Released (64bit only / usability / bugfix)


Rectifier in LDPE
#38
Hello Nils,

Rectifier in LDPE add the same edge line into two adjacent rect primitives. 6 edges and 2 quads
Code:
2 4 4.46 -22 -28 -52.41 26.7 -28
2 4 4.46 -22 -33 -52.41 26.7 -33
2 4 -52.41 26.7 -33 -76.02 -.82 -33
2 4 -52.41 26.7 -28 -76.02 -.82 -28
2 4 -52.41 26.7 -33 -52.41 26.7 -28
4 13 -52.41 26.7 -28 -76.02 -.82 -28 -76.02 -.82 -33 -52.41 26.7 -33
4 13 4.46 -22 -33 4.46 -22 -28 -52.41 26.7 -28 -52.41 26.7 -33
2 24 4.46 -22 -28 4.46 -22 -33

makes this code in LDPE
Code:
1 13 -64.215 12.94 -30.5 0 0 11.805 0 1 13.76 -2.5 0 0 rect3.dat
1 13 -23.975 2.35 -30.5 0 0 -28.435 0 1 24.35 2.5 0 0 rect.dat
One of the edge lines is included in both rect primitives.


but Rectifier in LETGUI makes this code
Code:
1 13 -64.215 12.94 -30.5 0 -1 11.805 0 0 13.76 -2.5 0 0 rect3.dat
1 13 -23.975 2.35 -30.5 0 0 28.435 0 1 -24.35 -2.5 0 0 rect3.dat
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Limited internet access... - by Nils Schmidt - 2016-11-05, 11:20
Rectifier in LDPE - by Magnus Forsberg - 2016-11-27, 19:41

Forum Jump:


Users browsing this thread: 2 Guest(s)