10174 UCS Imperial AT-ST [Star Wars]
I am glad to present the 10174 UCS AT-ST. … and I can tell you: For me this was a tough nut to crack!
Especially connecting the side parts of the drivers cap to the main model made me kind of desperate: It was necessary to fine adjust several angles successively in small steps by trial and error so as to get a best fit. After each step I had to check the result by visual means. Although I had not been able to avoid some small collisions I am finally satisfied with the result.
![[Image: 800x800.jpg]](http://bricksafe.com/files/papacharly/star-wars/10174%20-%20UCS%20Imperial%20AT-ST.jpg/800x800.jpg)
Download MPD-File (OMR compliant)
Done with LDcad
Rubber band generated with Philo’s “Rubber Belt Generator”
Errors: Missing display sticker
regards
Roland
I am glad to present the 10174 UCS AT-ST. … and I can tell you: For me this was a tough nut to crack!
Especially connecting the side parts of the drivers cap to the main model made me kind of desperate: It was necessary to fine adjust several angles successively in small steps by trial and error so as to get a best fit. After each step I had to check the result by visual means. Although I had not been able to avoid some small collisions I am finally satisfied with the result.
Download MPD-File (OMR compliant)
Done with LDcad
Rubber band generated with Philo’s “Rubber Belt Generator”
Errors: Missing display sticker
regards
Roland