Snapping part 99206 in LDCad
2016-05-30, 8:58 (This post was last modified: 2016-05-30, 9:44 by Jaco van der Molen.)
2016-05-30, 8:58 (This post was last modified: 2016-05-30, 9:44 by Jaco van der Molen.)
When I try to place part 99206
![[Image: 99206.jpg]](https://img.bricklink.com/P/86/99206.jpg)
it does not snap to the bottom (2x2) plate but one plate higher (or lower depending on how you look at it) at the "plate 1x2" part of this piece?
This is the case when placing other parts on this part too: they snap to the wrong studs.
it does not snap to the bottom (2x2) plate but one plate higher (or lower depending on how you look at it) at the "plate 1x2" part of this piece?
This is the case when placing other parts on this part too: they snap to the wrong studs.
Jaco van der Molen
lpub.binarybricks.nl
lpub.binarybricks.nl