LDraw.org Discussion Forums
Snapping part 99206 in LDCad - Printable Version

+- LDraw.org Discussion Forums (https://forums.ldraw.org)
+-- Forum: LDraw Programs (https://forums.ldraw.org/forum-7.html)
+--- Forum: LDraw Editors and Viewers (https://forums.ldraw.org/forum-11.html)
+--- Thread: Snapping part 99206 in LDCad (/thread-21547.html)

Snapping part 99206 in LDCad - Jaco van der Molen - 2016-05-30

When I try to place part 99206
[Image: 99206.jpg]
it does not snap to the bottom (2x2) plate but one plate higher (or lower depending on how you look at it) at the "plate 1x2" part of this piece?
This is the case when placing other parts on this part too: they snap to the wrong studs.

RE: Snapping part 99206 in LDCad - Merlijn Wissink - 2016-05-30

That's because the snap meta included with LDCad is wrong. I've made a fixed one, which you can download here (don't mind the other ones, just use 99206).

RE: Snapping part 99206 in LDCad - Roland Melkert - 2016-05-30

(2016-05-30, 11:13)Merlijn Wissink Wrote: That's because the snap meta included with LDCad is wrong. I've made a fixed one, which you can download here (don't mind the other ones, just use 99206).

He's right the 2x2 snap reference is located wrong sorry about that, I'll correct it for the next version.

RE: Snapping part 99206 in LDCad - Jaco van der Molen - 2016-05-30

Great thanks to both of you :-)

RE: Snapping part 99206 in LDCad - Art - 2016-08-11

Hi Everybody. I'm realy like LDcad and it's almost suitable for my needs. But is there a way to create arrows in LDcad 1.6 like in MLcad or better? Or maybe I can convert "LDcad permanent marker meta " into arrows which can be understood by LPub?

RE: Snapping part 99206 in LDCad - Jaco van der Molen - 2016-08-11

(2016-08-11, 12:48)Art Wrote: Hi Everybody. I'm realy like LDcad and it's almost suitable for my needs. But is there a way to create arrows in LDcad 1.6 like in MLcad or better? Or maybe I can convert "LDcad permanent marker meta " into arrows which can be understood by LPub?
Hi Art,
Perhaps it is better to ask this in a new post rather than a reply to this one which is a bit old and has another subject.
To answer it you should address Roland. He might read this too though...
Jaco

RE: Snapping part 99206 in LDCad - Art - 2016-08-11

(2016-08-11, 13:41)Jaco van der Molen Wrote:
(2016-08-11, 12:48)Art Wrote: Hi Everybody. I'm realy like LDcad and it's almost suitable for my needs. But is there a way to create arrows in LDcad 1.6 like in MLcad or better? Or maybe I can convert "LDcad permanent marker meta " into arrows which can be understood by LPub?
Hi Art,
Perhaps it is better to ask this in a new post rather than a reply to this one which is a bit old and has another subject.
To answer it you should address Roland. He might read this too though...
Jaco

Hi Jaco. Thanks for your reply. I'll follow your adwise.