Hi again Trevor
I have been looking into my problems with LPub3D, and found a solution to one of them.
The first problem I described in my original post, was that the partlist was not placed in the edge of the document when orienting the page as landscape. I fixed this by going to the first partlist and rightclicking on the page number next to it and selecting "move step number". Then i changed the "relavite to" setting from "page Header" to "page".
That did the trick
Regarding the render problem with using POV-ray, I still have the same problem.
I have been looking a bit more into what you describe above.
I have created a new empty ldr file with only two parts: a 3005 1x1 brick.
I placed the file in C:\temp and the folder has write access for all users.
I the started LPub 3D (newest version) and loaded the file. Then changed the rendere til POV-Ray.
POV-RAY: It comes with the following error:
IO Restrictions prohibit write access to 'C:\temp\Test\LPub\parts\3001_0_2100_150_DPCM_1_23_-45.png'
Failed to start render: Cannot open file.
I the left the POV-Ray window open and looked for the .pov file you describe under C:\temp\LPub3D\tmp.
There is none. there are 3 ldr files, but no .pov file.
and the C:\temp\Test\LPub\parts\3001_0_2100_150_DPCM_1_23_-45.png does not exist either.
I hope you can help me find out what is wrong
I have been looking into my problems with LPub3D, and found a solution to one of them.
The first problem I described in my original post, was that the partlist was not placed in the edge of the document when orienting the page as landscape. I fixed this by going to the first partlist and rightclicking on the page number next to it and selecting "move step number". Then i changed the "relavite to" setting from "page Header" to "page".
That did the trick
Regarding the render problem with using POV-ray, I still have the same problem.
I have been looking a bit more into what you describe above.
I have created a new empty ldr file with only two parts: a 3005 1x1 brick.
I placed the file in C:\temp and the folder has write access for all users.
I the started LPub 3D (newest version) and loaded the file. Then changed the rendere til POV-Ray.
POV-RAY: It comes with the following error:
IO Restrictions prohibit write access to 'C:\temp\Test\LPub\parts\3001_0_2100_150_DPCM_1_23_-45.png'
Failed to start render: Cannot open file.
I the left the POV-Ray window open and looked for the .pov file you describe under C:\temp\LPub3D\tmp.
There is none. there are 3 ldr files, but no .pov file.
and the C:\temp\Test\LPub\parts\3001_0_2100_150_DPCM_1_23_-45.png does not exist either.
I hope you can help me find out what is wrong