Philippe Hurbain Wrote:I use cut/paste for this, but maybe there are better ways. Problem with cut/paste is that you need to reinsert parts in the model at the right place, not always easy.
Roland Melkert Wrote:To move a selection to another existing submodel (during nested mode) you can use the 'move to current level' item from the reorganize menu. Just be sure to set the 'insert into' (on ses panel) to the intended target first.
If I'm reading Jetro's original question correctly he was asking about creating a new submodel from existing parts. If this is the case then by far the best way I've found is to right click->reorganize->move to submodel. Gives you options to reset orientation and move the bricks to the submodel's origin. One of my favorite LDcad accidental discoveries.