What's the best way to properly rotate the connecting rods in a V-engine such as the one below? (question initially asked to me by Max...). It is relatively easy to come to a good solution using a successive approximation method, but maybe there is an easier way?
LDCad tips and tricks
« Next Oldest | Next Newest »
| Messages In This Thread |
|
LDCad tips and tricks - by Philippe Hurbain - 2016-01-21, 13:16
Technic chain alignment on gears - by Philippe Hurbain - 2016-01-21, 13:32
Technic V-engine - by Philippe Hurbain - 2016-01-21, 13:36
Re: Technic V-engine - by Max Martin Richter - 2016-01-21, 13:51
Re: Technic V-engine - by Merlijn Wissink - 2016-01-21, 13:54
Re: Technic V-engine - by Philippe Hurbain - 2016-01-21, 14:00
Re: Technic V-engine - by Milan Vančura - 2016-01-21, 14:27
Re: Technic V-engine - by Roland Melkert - 2016-01-21, 18:45
Re: Technic chain alignment on gears - by Roland Melkert - 2016-01-21, 18:39
Re: Technic chain alignment on gears - by Philippe Hurbain - 2016-01-21, 19:07
Re: Technic chain alignment on gears - by Milan Vančura - 2016-01-21, 22:30
Re: Technic chain alignment on gears - by Roland Melkert - 2016-01-21, 22:45
Re: Technic chain alignment on gears - by Philippe Hurbain - 2016-01-26, 19:04
Re: LDCad tips and tricks - by Jason Smith - 2016-01-21, 22:53
|
Users browsing this thread: 4 Guest(s)