LDCad tips and tricks


Technic chain alignment on gears
#2
What is the best way to align the links of a chain around gears so that the chain bars go between teeth instead of going through them? I tried to rotate the path points, the whole chain then readjusted the path points to center on the gears, no way... of course I could rotate the gears instead, but since they are linked to other parts of the model I'm not keen of doing this!
   
Reply
« Next Oldest | Next Newest »



Messages In This Thread
LDCad tips and tricks - by Philippe Hurbain - 2016-01-21, 13:16
Technic chain alignment on gears - by Philippe Hurbain - 2016-01-21, 13:32
Technic V-engine - by Philippe Hurbain - 2016-01-21, 13:36
Re: Technic V-engine - by Max Martin Richter - 2016-01-21, 13:51
Re: Technic V-engine - by Merlijn Wissink - 2016-01-21, 13:54
Re: Technic V-engine - by Philippe Hurbain - 2016-01-21, 14:00
Re: Technic V-engine - by Milan Vančura - 2016-01-21, 14:27
Re: Technic V-engine - by Roland Melkert - 2016-01-21, 18:45
Re: LDCad tips and tricks - by Jason Smith - 2016-01-21, 22:53

Forum Jump:


Users browsing this thread: 5 Guest(s)