Hi
Sorry for the long time before my response.
I have been waiting for the download section here at the forum to be available again.
I have now done the following:
I have completely uninstalled the all-in-one installer, ldview, pov-ray, etc.
I have then downloaded and installed the newest all-in-one installer from the forum. I set it to install everything.
Otherwise I used all standard settings in the installer. I have used the preferred setting under the public user for the ldraw lib files.
I have given the local user modify rights for the install folder: C:\Program Files (x86)\LDraw (just in case).
I have then installed and configured ldview x64, POV-Ray 3.7 and LPUB 3D.
I created a folder here: C:\temp\test and gave the local user full access.
I created a test.ldr file containing 2 bricks and saved it to the above folder.
I opened the test.ldr with LPUB3D and changed the page setup to 35.5600 x 21.5900.
Then the following happenes when I change the preferred renderer:
LDView/LGLite: It still does not put the partlist to the edge of the document.
POV-RAY: It comes with the following error:
IO Restrictions prohibit write access to 'C:\temp\Test\LPub\parts\3001_0_2100_150_DPCM_1_23_-45.png'
Failed to start render: Cannot open file.
Regarding the complete.zip and ldrawunf.zip. I have downloaded and put them both here C:\Program Files (x86)\LDraw\
And as i mentioned earlier there is modify access to the folder for the local user.
I cant find anywhere where i can set the path to the above .zip files?
I have attached pictures of the setup in LPUB3D.
Perhaps I should mention that I am only logged on as a normal user, NOT Admin or power user.
Kind Regards
Knud
Sorry for the long time before my response.
I have been waiting for the download section here at the forum to be available again.
I have now done the following:
I have completely uninstalled the all-in-one installer, ldview, pov-ray, etc.
I have then downloaded and installed the newest all-in-one installer from the forum. I set it to install everything.
Otherwise I used all standard settings in the installer. I have used the preferred setting under the public user for the ldraw lib files.
I have given the local user modify rights for the install folder: C:\Program Files (x86)\LDraw (just in case).
I have then installed and configured ldview x64, POV-Ray 3.7 and LPUB 3D.
I created a folder here: C:\temp\test and gave the local user full access.
I created a test.ldr file containing 2 bricks and saved it to the above folder.
I opened the test.ldr with LPUB3D and changed the page setup to 35.5600 x 21.5900.
Then the following happenes when I change the preferred renderer:
LDView/LGLite: It still does not put the partlist to the edge of the document.
POV-RAY: It comes with the following error:
IO Restrictions prohibit write access to 'C:\temp\Test\LPub\parts\3001_0_2100_150_DPCM_1_23_-45.png'
Failed to start render: Cannot open file.
Regarding the complete.zip and ldrawunf.zip. I have downloaded and put them both here C:\Program Files (x86)\LDraw\
And as i mentioned earlier there is modify access to the folder for the local user.
I cant find anywhere where i can set the path to the above .zip files?
I have attached pictures of the setup in LPUB3D.
Perhaps I should mention that I am only logged on as a normal user, NOT Admin or power user.
Kind Regards
Knud