Hello Roland.
I hope I just found at least some hint about occasional crashes, finally: LDCad crashed two times today and it was, both cases, when I clicked on the "up" arrow in the part bin. Last log contains at least one line about that so I attach the whole log file.
Additional detail: I had "show snap points" turned on in both cases.
I hope this report helps at least somehow.
EDIT: new version of the archive, without the relative path of the file inside.
I hope I just found at least some hint about occasional crashes, finally: LDCad crashed two times today and it was, both cases, when I clicked on the "up" arrow in the part bin. Last log contains at least one line about that so I attach the whole log file.
Additional detail: I had "show snap points" turned on in both cases.
I hope this report helps at least somehow.
EDIT: new version of the archive, without the relative path of the file inside.